Recent Posts

Pages: [1] 2 3 ... 10
1
Hey Rob, maybe check the load adjusting valve on the rear axle. I had one that leaked from where the mechanical linkage went in and sucked in air. Took a while to find it. No signs of leaking and had to keep bleeding the brakes. Had to peel but the rubber cover to find the wet signs of leaking.

Will check everything again. There's no valve at the rear, just a union splitting the pipe to each rear wheel. That has all been replaced.

Didn't get the brakes bled today as I spent the rest of the day wallpapering the lounge. :D

I did fit my new HT leads though.
[/img]



2
Hey Rob, maybe check the load adjusting valve on the rear axle. I had one that leaked from where the mechanical linkage went in and sucked in air. Took a while to find it. No signs of leaking and had to keep bleeding the brakes. Had to peel but the rubber cover to find the wet signs of leaking.
3




better late than never as its been about a year of ownership... :)
5
it's good they are removable

 ;D

:D

And.............paw prints..............that would drive me nuts

I know! Damn cat got herself locked in the garage for 24 hours.

Wheels off to bleed the brakes again.



Don't worry that's not where I jacked it
6
vid 3 up now, haven't watched it yet
7
Technical Stuff / Re: (non vag) where to get 2013 BMW service in Auckland
« Last post by tusk on Today at 10:35:39 am »
Old thread I know but just in case...

Bellars motor works on the shore is excellent. BMWorkshops - Grey Lynn and Botany also very good.
8
The paw prints cross a red line for me too. Time to de-cat? ;D

My brother's beagle once jumped onto the bonnet of my old Bora, scratching the hell out of it in the process. It only lived to tell the tale as they'd left my place before I saw the damage!
9
And.............paw prints..............that would drive me nuts
10
80 - 90 - Coupe - quattro - S2 - RS 2 / Re: Build thread - Rob's Audi UR Quattro
« Last post by schattenblau on January 21, 2018, 04:50:41 pm »
it's good they are removable

 ;D
Pages: [1] 2 3 ... 10